Siemens SCALANCE W1750D CLI - Page 481

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
481
Syntax
show distributed-dhcp-branch-counts <type> <sip> <eip>
Parameter
Description
type
Displays the branch details for the distributed DHCPs based on the type of
the DHCP scope specified. The current release of Scalance W supports the
following distributed DHCP assignment modes.
•
Distributed, L2
•
Distributed, L3
<sip>
<eip>
Filters the branch count information based on an IP address range specified
for the starting IP address <sip> and ending IP address parameters. You
can specify up to four different ranges of IP addresses to filter the command
output.
Usage Guidelines
Use this command to view branch details for the distributed DHCP scopes.
Example
The following example shows the output of the show distributed-dhcp-branch-counts
command:
Branch Count Table
------------------
Client Count Upto
------------
Branch Count
-----------------
1
2
3
7
10
4
3
1
The output of this command displays the following information:
Parameter
Description
Client Count Upto
Displays the number of clients allowed for each DHCP branch.
Branch Count
Displays the number of branches allowed for the specified range of IP ad-
dresses.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode