Siemens SCALANCE W1750D CLI - Page 549

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
549
Usage Guidelines
Use this command without the optional <name> parameter to view a complete configuration
details of a network profile on the AP. Include the <name> parameter to display settings for a
single network SSID only.
Example
The following example shows the partial output of show network <name> command:
Name
:test
ESSID
:test
Status
:Enabled
Mode
:wpa2-aes
Band
:all
Type
:employee
Termination
:Disabled
Passphrase
:
WEP Key
:
WEP Key Index
1
VLAN
:
Server Load Balancing
:Disabled
MAC Authentication
:Disabled
L2 Auth Failthrough
:Disabled
Captive Portal
:Disabled
Exclude Uplink
:none
Hide SSID
:Disabled
Content Filtering
:Disabled
Auth Survivability
:Disabled
Auth Survivability time-out
24
RADIUS Accounting
:Disabled
Interim Accounting Interval
0
Radius Reauth Interval
0
DTIM Interval
1
Inactivity Timeout
1000
Legacy Mode Bands
:all
G Minimum Transmit Rate
1
G Maximum Transmit Rate
54
A Minimum Transmit Rate
6
A Maximum Transmit Rate
54
Multicast Rate Optimization
:Disabled
LEAP Use Session Key
:Disabled
Broadcast-filter
:none
Max Authentication Failures
0
Blacklisting
:Disabled
WISPr
:Disabled
Accounting mode
:Authentication
Work without usable uplink
:Disabled
Percentage of Airtime:
:Unlimited
Overall Limit:
:Unlimited
Per-user Limit:
:Unlimited
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode