Siemens SCALANCE W1750D CLI - Page 579

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
579
Parameter
Description
network <network-
name>
Displays aggregate information about a network profile configured on an
AP.Allows you to filter the command output for the AP, client, global, and
network profile statistics based on the specified number
[count]
Allows you to filter the command output for the AP, client, global, and
network profile statistics based on the specified number.
Usage Guidelines
Use this command to view the following information about APs, the clients connected to the
APs, and the corresponding AP cluster:
● Utilization trend—Displays information about the AP utilization, the number of clients
associated with an AP, Virtual Controller, or the AP network over the last 15 minutes.
● RF trends—Displays information the utilization, noise, or error threshold for an AP. It also
shows the current speed or signal strength for the clients in the network and the RF
information for the APs to which the clients are connected.
● Mobility Trail—Shows duration of the client is association with an AP and the name of the
AP to which it is currently connected.
Example
show stats ap
The following example shows the output for the
show stats ap <IP-address> command:
Util Level:good
Noise Level:good
Error Level:good
2.4 GHz Channel:7
5.0 GHz Channel:149+
Usage
-----
Timestamp CPU Utilization (%) Memory Free (MB) Neighboring APs [Valid] Neighboring
APs
[Interfering] Neighboring APs [Rogue] Neighboring Clients [Valid] Neighboring Clients
[Interfering] Clients Throughput [Out] (bps) Throughput [In] (bps)
--------- ------------------- ---------------- ----------------------- --------------
---------
------ ----------------------- --------------------------- --------------------------
------- -
------ ---------------------- ---------------------
00:34:46 8 164 4 239 0 1 8 1 93 99
00:34:17 8 164 4 239 0 1 8 1 186 199