Siemens SCALANCE W1750D CLI - Page 589

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
589
Syntax
show swarm {state|mode}
Parameter
Description
state
Displays the current status of the AP cluster.
mode
Displays the functioning mode of the AP cluster.
image-sync
Displays the image-sync AP list.
Usage Guidelines
Use this command to view the current status of the AP cluster and to view information about
the functioning mode of the AP cluster.
Example
The following example shows the output of show swarm state command:
AP Swarm State :swarm_config_sync_complete mesh auto eth0 bridging :no
Config in flash :yes factory SSID in flash :no extended-ssid configured :yes
extended-ssid active :yes Factory default stat :no
Source of system time :Image file Config load cnt 1
VC Channel index 1
IDS Client Gateway Detect :yes
Config Init success cnt for heartbeat 0
Config Init success cnt for register 0
Config Init skipping cnt for heartbeat 0
Config Init skipping cnt for register 0
Config Init last success reason :N/A Config Init last success time :N/A
The output of this command describes synchronization status of the AP cluster.
The following text shows an example output for the
show swarm mode command:
Swarm Mode :Cluster
Command Information
AP Platform
Command Mode
All platforms Privileged EXEC mode