Siemens SCALANCE W1750D CLI - Page 614

CLI Commands
4.16 S
SCALANCE W1750D CLI
614 Function Manual, 03/2019, C79000-G8976-C452-04
Syntax
show wifi-uplink {auth log |config | status}
Parameter
Description
auth log
Displays the authentication configuration details and an authentication log.
config
Displays the Wi-Fi configuration parameters enabled on an AP.
status
Displays the status of the Wi-Fi uplink.
Usage Guidelines
Use this command to view the information about status and configuration details for the Wi-
Fi uplink enabled on an AP.
Example
show wifi-uplink auth log
The following output is displayed for the
show wifi-uplink auth log command:
----------------------------------------------------------------------
wifi uplink auth configuration:
----------------------------------------------------------------------
----------------------------------------------------------------------
wifi uplink auth log:
----------------------------------------------------------------------
[1536]2013-05-08 23:42:06.647: Global control interface '/tmp/supp_gbl'
show wifi-uplink config
The following output is displayed for the
show wifi-uplink config command:
ESSID :Wifi
Cipher Suite :wpa-tkip-psk
Passphrase :test1234
Band :dot11a
The output for this command displays the following information:
Parameter
Description
ESSID
Displays the name of the network for which the Wi-Fi uplink is configured.
Cipher Suite
Displays the encryption settings configured for the Wi-Fi uplink. For exam-
ple, wpa-tkip-psk or wpa2-ccmp-psk.
Passphrase
Displays the WPA passphrase configured for the Wi-Fi uplink.
uplink-band <band>
Displays the band configured for the Wi-Fi uplink connection. For example,
dot11a and dot11g.