Siemens SCALANCE W1750D CLI - Page 624

CLI Commands
4.16 S
SCALANCE W1750D CLI
624 Function Manual, 03/2019, C79000-G8976-C452-04
bandwidth <bandwidth>
include-reverse
omit
on-boot
parallel
protocol [<tcp>|<udp>]
sec-to-measure <secs>
server-ip <server>
server-port <port>
time-interval <interval>
window
no...
Parameter
Description
Range
Default
speed test
Enables
speed-test
configuration sub-mode
for speed-test profile configuration.
— —
bandwidth
<bandwidth>
Configures the bandwidth length in Mbps. — —
include-reverse
The direction of traffic is reversed and sent
from the server to the client. This option
enables Iperf to run the speed test for an
extended duration.
— —
omit
Enter the number of initial seconds to omit. 1-5 —
on-boot
Configures the AP to run the speed test
during boot up.
— —
parallel
Enter the number of parallel client streams.
1-30
—
protocol
[<tcp>|<udp>]
Configures the speed test profile to be
executed using the UDP or TCP protocol.
— tcp
sec-to-measure
<secs>
Configures the duration of the speed test. 0-20 secs 10 secs
server-ip
<server>
Denotes the IP address of the Iperf server
which is used to run the speed test.
— —
server-port
<port>
Denotes the server port that the client
needs to connect to execute the speed test.
— 5201
time-interval
<internal>
Configures a time interval (secs) to run the
speed test on a regular basis. The mini-
mum time interval is 60 secs.
— —
window
Indicates the TCP window size or socket
buffer size sent to the server while run-
ning speed test.
64000–
16384000
—
no
Removes the speed-test profile configura-
tion.
— —