Siemens SCALANCE W1750D CLI - Page 626

CLI Commands
4.16 S
SCALANCE W1750D CLI
626 Function Manual, 03/2019, C79000-G8976-C452-04
Syntax
speed-test {<server> <protocol> [<bandwidth> | <include-reverse> | <omit> |
<parallel> | <sec- to-measure> | <server-port> | <window>]}
Parameter
Description
Range
Default
server
Enter the IP address of the Iperf server on
which the speed test needs to be run.
— —
protocol
[<tcp>|<udp>]
Enter the protocol type used for executing the
speed test.
— tcp
bandwidth
<bandwidth>
Enter the bandwidth length in Mbps. — —
include-reverse
The direction of traffic is reversed and sent
from the server to the client. This option ena-
bles Iperf to run the speed test for an extended
duration.
— —
omit
Enter the number of initial seconds to omit.
1-5
—
parallel
Enter the number of parallel client streams.
1-30
—
sec-to-measure
<secs>
Specify a duration (in secs) for the speed test. 0-20 secs 10 secs
server-port
<port>
Enter the server port that the client needs to
connect to execute the speed test.
— 5201
window
Indicates the TCP window size or socket buffer
size sent to the server while run- ning speed
test.
64000–
16384000
—
Usage Guidelines
Use this command to run a speed test on the Iperf server at any instant.
Example
The following example runs a speed test on the Iperf server:
(scalance)# speed-test 10.17.138.2 udp bandwidth 100 sec-to-measure 20 server-port
5201
parallel 12 omit 2 window 1
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode