Siemens SCALANCE W1750D CLI - Page 66

CLI Commands
4.3 C
SCALANCE W1750D CLI
66 Function Manual, 03/2019, C79000-G8976-C452-04
no…
no cellular-uplink-profile
Parameter
Description
Range
Default
cellular-uplink-
profile
<profile>
Configures a 3G or 4G cellular profile for an
AP.
— —
4g-usb-type <4G-usb-
type>
Configures the driver type for the 4G
modem.
ether-lte, pan-
tech-lte, none
—
modem-country <mo-
dem-country>
Specifies the country for the deployment. — —
modem-isp <mo-
dem isp>
Specifies the name of the ISP to connect. — —
usb-auth-type <usb_
authentication type>
Specifies the authentication type for USB. PAP, CHAP PAP
usb-dev <usb-dev>
Specifies the device ID of the USB modem.
—
—
usb-dial <usb-dial>
Specifies the parameter to dial the cell
tower.
— —
usb-init <usb-init>
Specifies the parameter name to initialize
the modem.
— —
usb-passwd <usb-
passwd>
Specifies the password for the account as-
sociated with the subscriber of the selected
ISP.
— —
usb-modeswitch <usb-
modeswitch>
Specifies the parameter used to switch mo-
dem from storage mode to modem mode.
— —
usb-type <usb-type>
Configures the driver type for the 3G
modem.
acm, airprime,
hso,
option, pantech-
3g, sierra-evdo,
sierra- gsm,none
—
usb-tty <usb-tty>
Specifies the modem tty port.
—
—
usb-user <usb-user>
Specifies the username of subscriber of the
selected ISP.
— —
no…
Removes the configuration settings of pa-
rameters under the
cellular-uplink-profile
command.
— —
no cellular-uplink-
profile
Removes the cellular uplink configuration
profile.
— —
Usage Guidelines
Use this command to configure a cellular uplink profile on an APand modem parameters 3G
or 4G uplink provisioning. SCALANCE W supports the use of 3G or 4G USB modems to
provide Internet backhaul to a network. The 3G or 4G USB modems can be used to extend
client connectivity to places where an Ethernet uplink cannot be configured. This enables the
APs to automatically choose the available network in a specific region.