Siemens SCALANCE W1750D CLI - Page 688

CLI Commands
4.20 W
SCALANCE W1750D CLI
688 Function Manual, 03/2019, C79000-G8976-C452-04
Command/Parameter
Description
Range
Default
wmm-video-dscp <dscp>
Allows you to specify the DSCP map-
ping value for the video traffic.
0—63 —
wmm-video-share
<share>
Allocates bandwidth for video traffic
generated from video streaming.
— —
wmm-voice-dscp <dscp>
Allows you to specify the DSCP map-
ping value for the voice traffic.
0—63 —
wmm-voice-share
<share>
Allocates bandwidth for voice traffic
generated from the incoming and out-
going voice communication.
— —
work-without-uplink
Allows the SSID to be used without an
uplink connection.
— —
wpa-passphrase
<passphrase>
Defines a WPA passphrase with which
you can generate a pre- shared key
(PSK).
— —
zone <zone>
Allows you to specify a zone for SSID. If
an SSID belongs to a zone, it is not
broadcast on any AP which does not
belong to the zone.
Usage Guidelines
Use this command to configure a WLAN SSID profile to set up an employee, voice, or guest
network.
Example
The following example configures an employee WLAN SSID profile:
(scalance)(config)# wlan ssid-profile employee1
(scalance)(SSID Profile "employee1")# type employee
(scalance)(SSID Profile "employee1")# essid employee1
(scalance)(SSID Profile "employee1")# enable
(scalance)(SSID Profile "employee1")# vlan 1
(scalance)(SSID Profile "employee1")# wpa-passphrase user@123
(scalance)(SSID Profile "employee1")# opmode wpa2-psk-aes
(scalance)(SSID Profile "employee1")# max-authentication-failures 0
(scalance)(SSID Profile "employee1")# mac-authentication
(scalance)(SSID Profile "employee1")# l2-auth-failthrough
(scalance)(SSID Profile "employee1")# termination
(scalance)(SSID Profile "employee1")# blacklist
(scalance)(SSID Profile "employee1")# mac-authentication