CLI Commands
4.20 W
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
695
Configures the maximum number of authentication
requests that can be sent to the server group.
1-5 3
Allows the APs to process RFC 3576- compliant
CoA and disconnect messages from the RADIUS
server. Disconnect messages cause a user ses-
sion to be terminated immediately, whereas the
CoA messages modify session authorization at-
tributes such as data filters.
— Disabled
only|acct-only}
When enabled, this parameter allows the AP to
send a status-server request to determine the
actual status of the authentication or accounting
server. This proves useful when there is a authen-
tication or request time
—RFC5997support
enabled for both authentication and accounting on
the authentication server.
—RFC5997 support enabled for authen-
tication only.
—RFC5997 support enabled for account-
ing onlyno rfc5997—Disables RFC5997 support
for the authentication server.
— Disabled
framed-
user{1x|cp|mac}
Changes the service type to frame for the follow-
ing RADIUS authentication methods:
• 1x—Changes Service-Type to Framed for
802.1X authentication.
• cp—Changes Service-Type to Framed for
Captive Portal authentication.
• mac—Changes Service-Type to Framed for
MAC authentication.
1x,cp,mac —
Configures a timeout value in second to determine
when a RADIUS request must expire.
The AP retries to send the request several times
(as configured in the Retry count), before the user
gets disconnected. For example, if the Timeout is
5 seconds, Retry counter is 3, user is disconnect-
1 to 30
seconds
5
Removes the configuration.
Usage Guidelines
Use this command to configure an external RADIUS server and a ClearPass Policy Manager
server as a RADIUS server for AirGroup CoA requests.
Example
The following example configures the external RADIUS server parameters:
(scalance)(config)# wlan auth-server RADIUS1
(scalance)(Auth Server <RADIUS1>)# ip 192.0.0.5
To Next Page
Loading...
