Siemens SCALANCE W1750D CLI - Page 699

CLI Commands
4.20 W
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
699
Parameter
Description
Range
webreputation <webrep>
Specifies a rule to allow or deny access to websites
based on security rating.
trustworth y-sites
low-risk- sites
moderate- risk-
sites
suspicious- sites
high-risk- sites
permit
Creates a rule to allow the specified packets. —
deny
Creates a rule to reject the specified packets. —
<opt0…opt11> Allows you to specify up to 10 options for network
ACLs and up to 12 options for DPI ACLs. You can
configure any of the following options:
• Log— Creates a log entry when this rule is trig-
gered.
• Blacklist— Blacklists the client when this rule is
triggered.
• Classify- media— Performs a packet inspection
on all non- NAT traffic and marks the critical traf-
fic.
• Disable- scanning— Disables ARM scanning
when this rule is triggered.
• DSCP tag— Specifies a DSCP value to prioritize
traffic when this rule is triggered.
• 802.1p priority— Sets an 802.1p priority.
• Application throttling: To set a bandwidth limit
based on application, application category, web
category or website reputation, you can configure
application throttling by using the throttle- down-
stream and throttle-up options. For example, you
can limit the bandwidth rate for video streaming
applications such as Youtube or Netflix, or set a
low bandwidth for suspicious websites.
—
redirect-blocked-https-traffic Configures an access rule to redirect users to a cus-
tom error page URL when accessing blocked HTTPS
websites for the WLAN SSID or Wired profile.
—
vlan <vlan-id>
Configures an access rule for VLAN assignment.
1–4093
no… Removes the definition of parameters under wlan
access-rule command.
—
no wlan access-rule
Removes the WLAN access rule configuration
—