NEC Xen IPK - Page 36

December 2004 NEC Business Solutions Ltd
16 – Chapter 1 DRAFT 3 Multiline Terminal Programming
Doc. No.: 8194 - Release 2.0 December 2004
21 Automated Attendant Extension Number
Assignment
Not Specified Tel No. (Up to 4 digits) phantom number only
(for each AA message 1~8)
22 Automated Attendant Direct Extension
Ring or Ring Assignment
Not Specified Tel No. (Up to 4 digits) real extension number
or CAR (for each AA message 1~8)
LK 1 System Mode
LK 4 Transfer/Automated Attendant (A.A.) (Continued)
Data
No.
Memory Block Name Default Value Programming Values
LK 1 System Mode
LK 5 SMDR/LCR
Data
No.
Memory Block Name Default Value Programming Values
02 SMDR Print Format All All, Mask Digits
13 Printer Connected Selection No No, PC, Printer
14 Printer Line Feed Control Selection No Yes, No
23 Outgoing Mode Selection
25 SMDR Valid Call Timer Assignment 00 = 0 sec. 00~99 sec. (input value) x 10 sec.
26 SMDR Incoming/Outgoing Print Selection All All, Outgoing, Incoming
LK 1 System Mode
LK 6 DSS
Data
No.
Memory Block Name Default Value Programming Values
00 Attendant Add-On Console to Telephone
Port Assignment
Refer to Attendant Add-On Console to Telephone Port Assignment on page 1-197.
03 DSS Call Voice/Tone Signal Selection Voice Tone, Voice
05 Attendant Add-On Console Key Selection Refer to Attendant Add-On Console Key Selection on page 1-199.
08 Attendant Transfer Selection During Live
Record
Yes No, Yes