NEC Xen IPK - Page 37

Xen IPK Programming Manual
Programming Manual DRAFT 3 Chapter 1 – 17
Doc. No.: 8194 - Release 2.0 December 2004
LK 1 System Mode
LK 7 ESP
Data
No.
Memory Block Name Default Value Programming Values
00 Doorphone Assignment No No (Not Assign)/Yes (Assign)
01 Doorphone Display Time Selection 10 sec. 10 sec., 30 sec., 60 sec., 90 sec.
02 External Speaker Connection Selection All Yes No, Yes per Speakers (A~C)
03 External Paging Alert Tone Selection Yes Yes, No
04 Doorphone Ringing Pattern Selection On Off, On, A~H
05 Doorphone Ringing Frequency Selection C A~H
06 External Paging Timeout Selection 5.0 min. 0.5 min., 1 min., 1.5. min., 2 min., 3 min.,
5 min., 8 min., No Limit
07 External Ring Relay Cycle Selection Pattern 3 Pattern 1, 2, 3, 4, 5, 6, Continuous
08 External Speaker Chime Selection Pre-Tone Pre-Tone/Chime (Start)/ Chime (Both)
09 External Speaker Chime Start
Time Selection
700 ms. 0~1500 msec = (Input value) x 100 msec
LK 1 System Mode
LK 8 PBR/Miscellaneous
Data
No.
Memory Block Name Default Value Programming Values
01 SLT or Automated Attendant/DISA to
PBR Selection
Off Off = Single Line Telephone
On = Automated Attendant/DISA
02 PBR Receive Level Assignment for
Automated Attendant/DISA
–46.0 dBm –33 dBm ~ –48 dBm @ iDB Step
04 Time Display (12h/24h) Selection 12-hour Display 12-hour Display
24-hour Display
07 Class of Service (Attendant)
Feature Selection 1
Refer to Class of Service (Attendant) Feature Selection 1 on page 1-220.
08 Class of Service (Station)
Feature Selection 2
Refer to Class of Service (Station) Feature Selection 2 on page 1-223.
09 Music on Hold Pattern Selection Pattern A Pattern A, Pattern B
10 PBR Interdigit Release Timer Selection 7 sec. 3 sec., 4 sec., 5 sec., 6 sec., 7 sec., 8 sec.,
9 sec., 10 sec.
11 System Refresh Timer Assignment 4 hr. No Refresh, 4 hr., 8 hr., 12 hr., 24 hr.
12 VRS Message Recording Time Selection 15 sec./16 Messages 15 sec./16 Messages
30 sec./8 Messages
60 sec./4 Messages
120 sec./2 Messages