NEC Xen IPK - Page 43

Xen IPK Programming Manual
Programming Manual DRAFT 3 Chapter 1 – 23
Doc. No.: 8194 - Release 2.0 December 2004
14 Tie/DID Line Type Assignment Immediate Second Dial Tone
Immediate
Delayed
Wink Start
15 Trunk DTMF Duration/Interdigit Selection 60 ms/80 ms 60 ms. /70 ms.
60 ms. /80 ms.
110 ms. /80 ms.
160 ms. /80 ms.
210 ms. /80 ms.
410 ms. /100 ms.
610 ms. /100 ms.
810 ms. /190 ms.
16 Tie Line Prepause Time Selection 0 sec. 0 sec., 0.5 sec., 1 sec., 1.5 sec., 2 sec.,
3 sec., 4 sec., 5 sec., 6 sec., 7 sec.,
8 sec., 9 sec., 10 sec., 11 sec., 12 sec.,
13 sec.
17 Tie Line Answer Detect Time Selection 390 ms 0 ms., 130 ms., 260 ms., 390 ms.,
520 ms., 650 ms., 780 ms., 910 ms.,
1040 ms., 1170 ms., 1300 ms., 1430 ms.,
1560 ms., 1690 ms., 1820 ms., 1950 ms.
18 Tie Line Release Detect Time Selection 260 ms 0 ms., 130 ms., 260 ms., 390 ms.,
520 ms., 650 ms., 780 ms., 910 ms.,
1040 ms., 1170 ms., 1300 ms., 1430 ms.,
1560 ms., 1690 ms., 1820 ms., 1950 ms
19 Tie Line/CO/PBX Incoming Signal Detect
Time Selection
Refer to Tie Line/CO/PBX Incoming Signal Detect Time Selection on page 1-356.
20 Tie Line Loop Off-Guard Time Selection 2 sec. 0 sec., 0.5 sec., 1 sec., 1.5 sec.,
2 sec., 3 sec., 4 sec., 5 sec., 6 sec.,
7 sec., 8 sec., 9 sec., 10 sec., 11 sec.,
12 sec., 13 sec.
21 Tie Line Length of Wink Signal Selection 180 ms. 30 ms., 60 ms., 90 ms., 120 ms., 150 ms.,
180 ms., 210 ms., 240 ms., 270 ms.,
300 ms., 330 ms., 360 ms., 390 ms.,
420 ms., 450 ms., 480 ms.
22 Tie Line Length of Delay Signal Selection 300 ms. 0 ms., 300 ms., 600 ms., 900 ms.,
1200 ms., 1500ms., 1800 ms., 2100 ms.,
2400 ms., 2700 ms., 3000 ms., 3300 ms.,
3600 ms., 3900 ms., 4200 ms., 4500 ms.
24 Tie Line Incoming Interdigit Timeout
Selection
11 sec. 1 sec., 2 sec., 3 sec., 4 sec., 5 sec.,
6 sec., 7 sec., 8 sec., 9 sec., 10 sec.,
11 sec., 12 sec., 13 sec, 14 sec., 15 sec.,
No Limit
25 Tie Line Wink/Delay Signal Detect
Timeout Selection
7 sec. 1 sec., 2 sec., 3 sec., 4 sec., 5 sec.,
6 sec., 7 sec., 8 sec., 9 sec., 10 sec.,
11 sec., 12 sec., 13 sec, 14 sec., 15 sec.,
No Limit
27 Tie Line Dial Tone Selection No Yes, No
28 Tie Line Reorder Tone Selection Sending (Yes) Sending (Yes)
Not Sending (No)
LK 3 CO/PBX Line Mode (Continued)
Data
No.
Memory Block Name Default Value Programming Values