NEC Xen IPK - Page 45

Xen IPK Programming Manual
Programming Manual DRAFT 3 Chapter 1 – 25
Doc. No.: 8194 - Release 2.0 December 2004
72 ISDN BRT Connection Configuration
90 Polarity Reverse Selection CO/PBX/DID/TLI = No
BRI/PRI = Yes
Yes, No
91 Trunk Type Selection CO CO
PBX
Tie
DID
CTX Assume 9
92 Trunk (Installed, DP/DTMF) Selection MF Nil
DP 10 pps
DP 20 pps
DTMF
LK 3 CO/PBX Line Mode (Continued)
Data
No.
Memory Block Name Default Value Programming Values
LK 4 Telephone Mode
Data
No.
Memory Block Name Default Value Programming Values
01 CO/PBX Ring Assignment (Day Mode) Refer to CO/PBX Ring
Assignment (Day Mode) on
page 1-405.
No Ring
Immediate Ring
Delayed Ring
02 CO/PBX Ring Assignment (Night Mode) Refer to CO/PBX Ring
Assignment (Night Mode)
on page 1-407.
No Ring
Immediate Ring
Delayed Ring
03 Doorphone Chime Assignment (Day
Mode)
Station Port 01 and 02
Chime (All Four
Doorphones)
Station Port 01~120 Chime on a per
Doorphone Basis
04 Doorphone Chime Assignment
(Night Mode)
Station Port 01 and 02
Chime (All Four
Doorphones)
Station Port 01~120 Chime on a per
Doorphone Basis
05 Automatic Outgoing CO/PBX Line
Selection
Tel Port (01-CO) = All
Trunks (01-64) set to
“YES”
NO, YES
07 Code Restriction Class Assignment (Day
Mode)
All Stations Class 00 Class 00~15 per Station
08 Code Restriction Class Assignment
(Night Mode)
All Stations Class 00 Class 00~15 per Station
09 Telephone to Tenant Assignment All Telephones Tenant 00 Tenant Number 00~47
10 Station Number Assignment Refer to Station Number Assignment on page 1-417.
11 Ringing Line Preference Selection Yes No, Yes
12 Line Key Selection for Telephone Mode Refer to Line Key Selection for Telephone Mode on page 1-419.
13 CO/PBX Busy Forward Station
Assignment
Not Specified Tel Port 01~96
14 Intercom Master Hunt Number Selection No No, Yes