NEC Xen IPK - Page 542

December 2004 NEC Business Solutions Ltd
522 – Chapter 1 DRAFT 3 Section 5, Function Timer Chart
Doc. No.: 8194 - Release 2.0 December 2004
Hold Recall Time
Selection
(Exclusive)
1-1-63
Specify the time for Exclusive Hold
Recall.
30 sec. 1 min. No Limit
Attendant Add-On
Console Transfer/
Camp-On Recall
Timer Selection
1-1-64
Specify the time for a ring transfer
from the DSS Console until the
recall alarm is sent.
30 sec. 1 min. 10 min.
First Delay
Announcement
Start Time Selection
1-1-71
Specify the time between
receiving an incoming CO call and
sending the First Delay
Announcement to the caller.
0 sec. 20 sec. 60 sec.
First to Second
Delay
Announcement
Interval Time
Selection
1-1-73
Specify the time between the First
and Second Delay
Announcement.
0 sec. 20 sec. No Limit
Second Delay
Announcement
Repeat Interval
Time Selection
1-1-75
Specify the time between repeated
Second Delay Announcement.
0 sec. 20 sec. No Limit
Delayed Ringing
Timer Assignment
(CO)
1-1-77
Specify the time for delayed
ringing on incoming outside line
calls.
0 sec. 15 sec 99 sec.
ISDN DTMF
Duration/Interdigit
Time Selection
1-180
Specify tone duration and interdigit
time of Dual-Tome Multifrequency
(DTMF) signals for the ISDN
Trunk.
70/60 ms. 100/70 ms. 900/200 ms.
ISDN Dial Interval
Timer Selection
1-1-81
Specify the dial interval timer for
ISDN lines when dialling from a
PHS
2 sec. 8 sec. 32 sec.
Internal Paging
Timeout Selection
1-2-00
Specify the time allowed for
paging.
90 sec. 90 sec. No Limit
Automatic Callback
Release Timer
Selection
1-2-02
Time duration before Automatic
Callback is automatically
cancelled.
30 sec. 30 min. 30 min.
Call Forward No
Answer Timer
Selection
1-2-22
Specify time before ICM or Trunk
calls are forwarded.
4 sec. 8 sec. 60 sec.
System Call Park
Recall Time
Selection
1-2-23
Time before a parked call recalls
to the station that parked the call.
30 sec. 1 min 10 min.
Table 1-3: Function Timer Chart (Continued)
Timer
Memory
Block
Definition
Timing Value
Minimum Default Maximum