NEC Xen IPK - Page 546

December 2004 NEC Business Solutions Ltd
526 – Chapter 1 DRAFT 3 Section 5, Function Timer Chart
Doc. No.: 8194 - Release 2.0 December 2004
Tie Line Length of
Delay Signal
Selection
3-22
Specify the time a delay pulse is
sent to another system.
0 ms. 300 ms. 4500 ms.
Tie Line Incoming
Interdigit Timeout
Selection
3-24
Specify the maximum time during
the incoming call detection
process. If an address signal is not
received within a specified time,
an error tone is returned to the
other system.
1 sec. 6 sec. No Limit
Tie Line Wink/Delay
Signal Detect
Timeout Selection
3-25
Specify the maximum time for
receiving an acknowledgment
signal from a distant system
before sending a busy tone.
1 sec. 7 sec. No Limit
Disconnect
Recognition Time
Selection
3-33
Specify a minimum time for a
disconnected circuit to be
accessed again.
0 sec. 0.3 sec 1.5 sec.
DIT Delay Answer
Timer Selection
3-61
This Memory Block is used to
specify the time and incoming CO/
PBX call will ring before changing
to DIT.
0 sec. 5 sec. 60 sec.
Table 1-3: Function Timer Chart (Continued)
Timer
Memory
Block
Definition
Timing Value
Minimum Default Maximum