Siemens SCALANCE W1750D CLI - Page 281

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
281
Column
Description
Last change channel/pwr
Indicates the time since the channel and power assignment was up-
dated.
Next Check channel/pwr
Indicates the next interval at which the channel and power assign-
ment will be verified.
Assignment Mode
Indicates if the ARM is assignment is applicable to a single band or
dual band.
show ap arm scan-times
The
show ap arm scan-times command shows the AM channel scan times for an AP. The
following example shows the output of the
show ap arm scan-times command:
Channel Scan Time
-----------------
channel assign-time(ms) scans-attempted scans-rejected dos-scans flags timer-tick
------- --------------- --------------- -------------- --------- ----- ----------
36 2483300 1530 0 0 DVACFT 172120
40 576170 1547 0 0 DVACPT 172139
44 9945940 1454 0 0 DVACFT 172145
48 170500 1550 0 0 DVACPT 172158
52 167420 1522 0 0 DVACT 172046
56 65450 595 0 0 DVCT 171880
60 169840 1544 0 0 DVACT 172052
64 170390 1549 0 0 DVACT 172063
149 68631720 952 0 0 DVACFT 172074
153 32278480 1268 0 0 DVACPT 172088
157 38634770 1207 0 0 DVACFT 172132
161 20620710 1361 0 0 DVACPT 172161
165 170280 1548 0 0 DVACT 172110
1 86424330 903 0 0 DVACFT 172161
2 53570 487 0 0 DC 171936
3 55660 506 0 0 DC 171980
4 88550 805 0 0 DC 172030
5 327140 2974 0 0 DVACP 172124
6 40459820 2562 0 0 DVACT 172110
7 334620 3042 0 0 DVACF 172137
8 89210 811 0 0 DC 171627
9 92620 842 0 0 DC 171684
10 192940 1754 0 0 DAC 172144