Siemens SCALANCE W1750D CLI - Page 336

CLI Commands
4.16 S
SCALANCE W1750D CLI
336 Function Manual, 03/2019, C79000-G8976-C452-04
Parameter
Description
UAPSD OverflowDrop
Shows the number of packets dropped due to Unscheduled Automatic
Power Save Delivery (U-APSD) overflow.
Last SNR
Indicates the last recorded signal-to-noise ratio.
Last SNR CTL0
Indicates the signal-to-noise ratio for the last received data packet on the
primary (control) channel 0. This parameter is only displayed for APs
operating in 40 MHz mode.
Last SNR CTL1
Indicates the signal-to-noise ratio for the last received data packet on the
secondary (control) channel 1. This parameter is only displayed for APs
operating in 40 Mhz mode.
Last SNR CTL2
Indicates the signal-to-noise ratio for the last received data packet on the
secondary (control) channel 2. This parameter is only displayed for APs
operating in 40 MHz mode.
Last ACK SNR
Indicates the signal-to-noise ratio for the last received ACK packet.
Last ACK SNR CTL0
Indicates the signal-to-noise ratio for the last received ACK packet on the
primary (control) channel 0. This parameter is only displayed for APs
operating in 40 MHz mode.
Last ACK SNR CTL1
Indicates the signal-to-noise ratio for the last received ACK packet on the
primary (control) channel 1. This parameter is only displayed for APs
operating in 40 MHz mode.
Last ACK SNR CTL2
Indicates the signal-to-noise ratio for the last received ACK packet on the
primary (control) channel 2. This parameter is only displayed for APs
operating in 40 MHz mode.
Last ACK SNR EXT0
Indicates the signal-to-noise ratio for the last received ACK packet on the
secondary (extension) channel 0. This parameter is only displayed for
APs operating in 40 MHz mode.
Last ACK SNR EXT1
Indicates the signal-to-noise ratio for the last received ACK packet on the
secondary (extension) channel 1. This parameter is only displayed for
APs operating in 40 MHz mode.
Frames Received
Shows the number of frames received.
Rx Data Frames
Shows the number of data frames received.
Null Data Frames
Shows the number of null data frames received.
Rx Mgmt Frames
Shows the number of management frames received.
PS Poll Frames
Shows the number of power save poll frames received.
Rx<n>Mbps
Shows the number of frames received at <n> Mbps, where <n> is a value
between 6 and 300.
.Tx WMM Shows the number of Wi-Fi Multimedia (WMM) packets transmitted for
the following access categories. If the AP has not transmitted packets in a
category type, this data row will not be displayed in the output of the
command.
Tx WMM [BE]:
Best Effort
Tx WMM [BK]:
Background
Tx WMM [VO]:
VoIP
Tx WMM [VI]:
Video