Siemens SCALANCE W1750D CLI - Page 424

CLI Commands
4.16 S
SCALANCE W1750D CLI
424 Function Manual, 03/2019, C79000-G8976-C452-04
Syntax
show clients [<diff>| accounting <mac>| checksum <mac>| debug| roaming| status <mac>|
wired [debug]]
Parameter
Description
<diff>
Displays difference summary of the client table since the specified inter-
val.
accounting <mac>
Displays accounting information for a specific client MAC address.
checksum <mac>
Filters checksum errors for a specific client MAC address.
debug
Displays the AP client configuration details, which can be used for debug-
ging purpose.
roaming
Displays information about roaming clients.
status <mac>
Displays the current status for a client based on the specified MAC ad-
dress.
wired [debug]
Displays the list of clients connected to wired or Ethernet interface. You
can also use the optional debug parameter to view the end-to-end infor-
mation of the wired clients for debugging purpose.
Usage Guidelines
Use this command to view information about the AP clients. The AP client table provides
basic information about the clients. For detailed information of each client, use the required
parameter and specify the MAC address of the client.
Example
show clients and show clients wired
The following output is displayed for the
show clients command:
Client List
-----------
Name IP Address MAC Address OS ESSID Access Point
---- ---------- ----------- -- ----- ------------
132-15-Auto-PC-Change 10.17.133.241 08:ed:b9:e1:51:7b rev_ipv6 ac:a3:1e:cd:46:94
Channel Type Role IPv6 Address Signal Speed (mbps)
------- ---- ---- ------------ ------ ------------
36+ AN rev_ipv6 2001:470:36:5c3:ffff:ffff:ffff:64 0(poor) 0(poor)
`
Number of Clients 1
Info timestamp :605085
A similar output is displayed for the
show clients wired command.