Siemens SCALANCE W1750D CLI - Page 425

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
425
The client list in the command output for both wireless and wired clients provides the
following information:
Column
Description
Name
Displays the name of the client
IP address
Displays the IP address of the client.
MAC address
Displays the MAC address of the client.
OS
Indicates the OS running on the client system.
Network
Indicates the SSID and network to which the client is connected.
Access Point
Indicates the IP address of the Access Point to which the client is connect-
ed.
Channel
Indicates the channel assigned to the client.
Type
Indicates the type of the Wi-Fi client device.
Role
Indicates the role assigned to the client.
Signal
Indicates the current signal strength of the client, as detected by the AP.
Speed(Mbps)
Indicates the current speed at which data is transmitted. When the client is
associated with an AP, it constantly negotiates the speed of data transfer. A
value of 0 means that the AP has not received any packets from the client
for some time.
show clients <diff>
The
show clients <diff> command displays the change in the clients table data that occurred
during the specified interval. For example, if the value specified for <diff> parameter is 10
seconds, the client table displays the changes such as signal strength or speed that
occurred since the last 10 seconds.
show accounting <mac>
The
show accounting <mac> command displays the accounting information such as status
and session ID for a specific client MAC address.
show checksum <mac>
The following output is displayed for the
show checksum <mac> command:
Mac Address:08:ed:b9:e1:51:7d Basic info
----------
mac
---
08 ed b9 e1 51 7d bssid
d8 c7 c8 3d 3d 52 ap_ip
0a 11 58 ba name
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00