Siemens SCALANCE W1750D CLI - Page 51

CLI Commands
4.1 A
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
51
client-match [bad-snr <snr> | [calc-interval <interval>| calc-threshold <thresh>|
clientthresh<thresh> | debug <level>|
good-snr <snr> | holdtime <second> | key <key> | maxadoption<adopt>| max-
request <req>| nb-matching <percentage> |report-interval <interval>|restriction-
timeout slb-mode <mode>|snr-thresh <snr>| sta-entry-age <age> | vbr-entry-age <age>]
error-rate-threshold <percent>
error-rate-wait-time <secs>
free-channel-index <idx>
g-channels <channel>
ideal-coverage-index <idx>
max-tx-power
min-tx-power
scanning
spectrum-load-balancing [calc-interval <Seconds> |calc-threshold <threshold> | nb-
matching <Percentage>]
wide-bands {<none>| <all>| <2.4>| <5>}
no…
Command/Parameter
Description
Range
Default
80mhz-support
Enables the use of 80 MHz channels on APs
with 5 GHz radios, which support a VHT.
NOTE:
Only the APs that support 802.11ac
can be configured with 80 MHz channels.
— —
a-channels <a-
channel>
Configures 5 GHz channels. — —
air-time-fairness-
mode
{<default-access>|
<fair-access>|
<preferred-access>}
Allows equal access to all clients on the wire-
less medium, regardless of client type, capa-
bility, or operating system and prevents the
clients from monopolizing resources. You can
configure any of the following modes:
• default- access—To provide access based
on client requests. When this mode is
configured, the per user and per SSID
bandwidth limits are not enforced.
• fair- access—To allocate Airtime evenly
across all the clients.
• preferred- access—To set a preference
where 802.11n clients are assigned more
airtime than 802.11a or 802.11g. The
802.11a or 802.11g clients get more air-
time than 802.11b. The ratio is 16:4:1.
default-access,
fair-access,
preferred-
access
default- access
default-
access
backoff-time <secs>
Configures the time when an AP backs off
after requesting a new channel or power.
10 - 3600 240