CLI Commands
4.1 A
SCALANCE W1750D CLI
52 Function Manual, 03/2019, C79000-G8976-C452-04
{<balance-bands>|
<prefer- 5ghz>|
<force-5ghz>|
<disable>
Assigns the dual-band capable clients to the 5
GHz band on dual-band. It reduces co-
channel interferenc e and increases available
bandwidth for dual- band clients, because
there are more channels on the 5 GHz band
than on the 2.4 GHz band. You can configure
any of the following band- steering modes:
• balance- bands—To allow the APs to
balance the clients across the two 2.4
GHz and 5 GHz radio and to utilize the
available bandwidth.
• prefer- 5ghz—To allow the AP to steer the
client to 5 GHz band (if the client is 5 GHz
capable). However, the AP allows the cli-
ent connection on the 2.4 GHz band if the
client persistently attempts for 2.4 GHz
association.
• force- 5ghz—To enforce 5 GHz band
steering mode on the APs, so that the 5
GHz capable clients are allowed to use
only the 5 GHz channels.
• disable—To allow the clients to select the
bands
balance-bands,
prefer-5ghz,
force-5ghz,
disable
balance-
bands
aware-arm-disable
With this parameter, ARM ignores the inter-
nally calculated channel quality metric and
initiates channel changes based on thresh-
olds defined in the profile. ARM chooses the
channel based on the calculated interference
— Disabled
threshold <thresh>
Specifies the channel quality percentage
below which ARM initiates a channel change.
0 - 100 70
wait-time <secs>
Specifies the time that the channel quality is
below the channel quality threshold value to
initiate a channel change.
If current channel quality is below the
specified channel quality threshold for this
wait time period, ARM initiates a channel
1 - 3600 120
Enables the client aware feature. When ena-
bled, the AP will not change channels for the
Access Points when clients are active, except
for high priority events such as radar or ex-
cessive noise. The client aware feature must
be enabled in most deployments for a stable
— Enabled
To Next Page
Loading...
