Siemens SCALANCE W1750D CLI - Page 522

CLI Commands
4.16 S
SCALANCE W1750D CLI
522 Function Manual, 03/2019, C79000-G8976-C452-04
Syntax
show l3-mobility {config| datapath| events [<count> <mac>] status}
Parameter
Description
config
Displays the L3 mobility configuration details for an AP.
datapath
Displays the datapath statistics associated with L3 mobility.
events [<count>
<mac>]
Displays L3 mobility events for all AP clients or individual clients filtered
based on MAC address.
status
Displays the L3 mobility status for an AP.
Usage Guidelines
Use this command to view the L3 mobility information for an AP.
Example
show l3-mobility config
The following example shows the output of the
show l3-mobility config command:
Flags
-----
Type Value
---- -----
Home Agent Load Balancing enable
Virtual Controller Table
------------------------
VirtualRoaming Client Table
--------------------
Client MAC Home Vlan VAP Vlan Tunnel ID Status Virtual Controller IP Peer IP Old AP
IP Device Name
---------- --------- -------- --------- ------ --------------------- ------- --------
- -------
----
Tunnel Table
------------
Peer IP Local Tunnel ID Remote Tunnel ID Use Count Type
------- --------------- ---------------- --------- ----
Virtual Controller Table
------------------------
Virtual Controller IP Type HAP IP Local Tunnel ID Remote Tunnel ID