EasyManua.ls Logo

Siemens SCALANCE W1750D CLI - Page 714

Siemens SCALANCE W1750D CLI
762 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CLI Commands
4.20 W
SCALANCE W1750D CLI
714 Function Manual, 03/2019, C79000-G8976-C452-04
Parameter
Description
Range
Default
set-vlan <attribute>
{equals|not-equals|
starts-with| ends-with|
contains} <operator>
<VLAN-ID>| value-of}
Assigns a VLAN to the clients. The first
rule that matches the configured condi-
tion is applied.
You can specify any of the following
conditions:
contains
The rule is applied only
if the attribute value contains the
specified string.
ends-with
The rule is applied
only if the attribute value ends with
the specified string.
equals
The rule is applied only if
the attribute value is equal to the
specified string.
not-equals
The rule is applied
only if the attribute value is not
equal to the specified string.
starts-with
The rule is applied
only if the attribute value begins
with the specified string.
value-of
This rule sets the VLAN
to the value of the attribute re-
turned. To set a user role, the value
of the attribute must already be
configured on the AP.
shutdown
Shuts down the admin status port. up, down up
spanning-tree
Enables Spanning Tree Protocol on the
wired profile.
STP ensures that there are no loops in
any bridged Ethernet network and
operates on all downlink ports, regard-
less of forwarding mode. STP will not
operate on the uplink port and is sup-
ported only on APs with three or more
ports. By default Spanning Tree is
disabled on wired profiles.
speed <speed>
Assigns a value for indicating speed of
client traffic based on the capabilities of
the client, the AP, and the cable.
10,100,200,
auto
auto
storm-control-broadcast
Enables thebroadcast storm con-
trol.When this parameter is enabled, if
the AP detects a loop on one of its
Ethernet port, it shuts down the Ether-
net port. This prevents the AP from
receiving or sending any frames.
Disabled
storm-control-threshold
<threshold>
Specify the broadcast packets per
second on each Ethernet port of an AP
before the Ethernet port is shut down.
100 -
1000000
packets per
second
2000
packets per
second

Table of Contents