Siemens SCALANCE W1750D CLI - Page 715

CLI Commands
4.20 W
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
715
Parameter
Description
Range
Default
switchport-mode <mode>
Defines the switchport mode for the
wired profile.
You can specify any of the following
modes:
•
Access
— Use this mode to allow
the port to carry a single VLAN
specified as the native VLAN.
•
Trunk
— Use this mode to allow the
port to carry packets for multiple
VLANs specified as allowed
VLANs.
access, trunk trunk
trusted
Supports trusted ports to enable wired
users in an L3 mode to connect to a
switch or a router that is connected to
the downlink port of an AP. In this
mode, mac- authentication, dot1x,
and
captive-portal parameters will
not take any effect.
— No
type <type>
Defines the primary usage of the wired
profile
employee,
guest
employee
uplink-enable
Enables uplink for the wired profile
—
—
use-ip-for-calling-station The IP address of the client will be
used as the calling- station-id
— —
no wired-port-profile <port> Removes the wired portprofile configu-
ration.
— —
no…
Removes any existing configuration
—
—
Usage Guidelines
Use this command to create a wired profile for employee and guest users. The Ethernet
ports allow third-party devices such as VoIP phones or printers (which support only wired
connections) to connect to the wireless network. You can also configure an ACL for
additional security on the Ethernet downlink.
Example
The following example configures a wired profile for an employee network:
(scalance)(config)# wired-port-profile employeeWired1
(scalance)(wired ap profile"employeeWired1")# type employee
(scalance)(wired ap profile"employeeWired1")# speed auto
(scalance)(wired ap profile"guestWired1")# dot3bz
(scalance)(wired ap profile"employeeWired1")# duplex auto
(scalance)(wired ap profile"employeeWired1")# no shutdown
(scalance)(wired ap profile"employeeWired1")# poe