118
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Basic software procedures
5.1.6 Switching on the ID indicator
When working in a datacenter environment or a server room, switch on the ID
indicator on the front and rear connector panels of the server for easy
identification.
I
For further information, refer to section "Locating the defective server" on
page 55 or to the "ServerView Suite Local Service Concept (LSC)" and
"Integrated Remote Management Controller" user guides.
Using the ID button on the front panel
Ê
Press the ID button on the front panel to switch on the system identification
LEDs.
I
For further information, refer to section "Indicators on the front panel"
on page 554.
Using the iRMC web frontend
Ê
Enter the ServerView iRMC web frontend.
Ê
Under
System Overview
, click
Identify LED On
to switch on the ID indicators.
Using ServerView Operations Manager
Ê
In ServerView Operations Manager
Single System View
press the
Locate
button in the title bar to switch on the ID indicators.
To Next Page
Loading...
Need help?
General