TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
315
Expansion cards and backup units
9.3.7.3 Installing a new expansion card
Ê
If applicable, install a slot bracket on the new expansion card as described
in section "Installing a slot bracket" on page 293.
Ê
Install the expansion card as described in section "Installing expansion
cards in riser modules" on page 308.
9.3.7.4 Concluding steps
Ê
"Reassembling" on page 74
Ê
Reconnect all external cables to the replaced expansion card.
Ê
"Connecting the power cord" on page 87
Ê
"Enabling replaced components in the system BIOS" on page 131
Ê
Inform the customer about changed WWN, MAC and SAS addresses. For
further information, refer to section "Looking up changed MAC / WWN
addresses" on page 137.
Ê
"Updating the NIC configuration file in a Linux and VMware environment" on
page 134
Ê
"Updating RAID controller firmware" on page 122
Ê
"Enabling SVOM boot watchdog functionality" on page 130
Ê
"Resuming BitLocker functionality" on page 136
Ê
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section "Note on
network settings recovery" on page 304.
Ê
If applicable, "After replacing / upgrading LAN controllers" on page 140
To Next Page
Loading...
Need help?
General