TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
329
Expansion cards and backup units
Ê
If applicable, update the firmware of the RAID controller that has been
connected to the FBU as described in section "Updating RAID controller
firmware" on page 122.
Ê
"Enabling SVOM boot watchdog functionality" on page 130
I
The recalibration of the FBU starts automatically, and finishes within a
few minutes.
9.4.5 Replacing a TFM
V CAUTION!
For further safety information, please refer to chapter "Important
information" on page 43.
9.4.5.1 Preliminary steps
Ê
"Disabling SVOM boot watchdog functionality" on page 112
Ê
"Locating the defective server" on page 55
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
Disconnect the SAS cables from the SAS RAID controller.
Ê
Remove the SAS RAID controller from its slot as described in section
"Removing expansion cards from standard slots" on page 300.
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools:
Phillips PH1 / (+) No. 1 screw driver
To Next Page
Loading...
