456
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
System board and components
Figure 340: Installing the UFM
Ê
Connect the UFM to the system board. The UFM spacer must click into the
hole on the system board.
14.3.1.3 Concluding steps
Ê
If applicable, install the expansion card in slot 1 as described in section
"Installing expansion cards in standard slots" on page 295.
Ê
"Reassembling" on page 74
Ê
"Connecting the power cord" on page 87
Ê
"Switching on the server" on page 90
Ê
"Enabling SVOM boot watchdog functionality" on page 130
Ê
"Resuming BitLocker functionality" on page 136
14.3.1.4 Software configuration
I
For the Japanese market, follow the instructions provided separately.
In order to setup the ESXi configuration, the VMware ESXi Recovery Tools CD
is required. An ISO image of the CD is available from the Fujitsu service
partners portal at the following https address:
https://globalpartners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/
Pages/default.aspx
.
Ê
Sign in and choose your PRIMERGY server.
Ê
Select the
Software & Tools Documentation
category.
To Next Page
Loading...
