TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
363
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
"Removing the system air duct" on page 91
Ê
"Locating the defective component" on page 57
10.4.2 Removing the defective memory module
Ê
Remove the memory module as described in section "Removing memory
modules" on page 361.
10.4.3 Installing a new memory module
Ê
Install the memory module as described in section "Installing memory
modules" on page 359.
10.4.4 Concluding steps
Ê
"Installing the system air duct" on page 92
Ê
"Reassembling" on page 74
Ê
"Connecting the power cord" on page 87
Ê
If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 119
Ê
"Resetting the error status after replacing memory modules or processors"
on page 126
Ê
"Enabling SVOM boot watchdog functionality" on page 130
Ê
"Enabling replaced components in the system BIOS" on page 131
Ê
"Verifying the memory mode" on page 132
Ê
"Resuming BitLocker functionality" on page 136
To Next Page
Loading...
