EasyManuals Logo

Fujitsu PRIMERGY TX2560 M2 Upgrade And Maintenance Manual

Fujitsu PRIMERGY TX2560 M2
568 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #452 background imageLoading...
Page #452 background image
452
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
System board and components
SATA DOM
With the Innodisk Serial ATA Disk on Module (SATADOM) an internal SSD
is offered. This SSD can be configured as a boot device or data storage
device.
iRMC microSD card
The iRMC microSD card is necessary for using the embedded Lifecycle
Management (eLCM) functionality of the iRMC.
14.2 CMOS battery
14.2.1 Replacing the CMOS battery
Safety notes
V CAUTION!
The CMOS battery (CR2032) must be replaced with an identical
battery or with a battery type recommended by the manufacturer.
Keep lithium batteries away from children.
Do not throw batteries into the trash can. Lithium batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
protection" in the operating manual of your server.
Ensure to insert the CMOS battery with the positive pole facing
up!
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools:
tool-less; recommended: tooth pick

Table of Contents

Other manuals for Fujitsu PRIMERGY TX2560 M2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY TX2560 M2 and is the answer not in the manual?

Fujitsu PRIMERGY TX2560 M2 Specifications

General IconGeneral
BrandFujitsu
ModelPRIMERGY TX2560 M2
CategoryServer
LanguageEnglish

Related product manuals