484
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
System board and components
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
14.7.1.1 Preliminary steps
Ê
"Locating the defective server" on page 55
Ê
"Note on network settings recovery" on page 484
Ê
"Suspending BitLocker functionality" on page 111
Ê
"Disabling SVOM boot watchdog functionality" on page 112
Ê
"Locating the defective server" on page 55
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
Disconnect all external cables.
Ê
"Getting access to the component" on page 61
Ê
"Removing a PSU" on page 149
Ê
"Removing the system air duct" on page 91
Ê
"Removing the system fan holder" on page 93
Ê
Remove the following components from the system board as shown in the
related sections:
– Heat sinks: "Removing heat sinks" on page 387
I
Leave the CPU on the defective board for now.
– Memory modules: "Removing memory modules" on page 361
I
Ensure to take note of the memory modules’ mounting positions
for reassembly.
To Next Page
Loading...
