140
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Basic software procedures
V CAUTION!
Please note that you can only set the ATD flag. Resetting the ATD flag
using the Chassis ID Prom Tool is not possible!
5.2.19 Configuring LAN teaming
Use ServerView Operations Manager to obtain detailed information on existing
LAN teams:
Ê
In ServerView Operations Manager
Single System View
select
System Status
from the
Information / Operation
menu.
Ê
Under
Network Interfaces
select
LAN Teaming
.
Ê
The
Network Interfaces (Summary)
overview shows all configured LAN teams
and their components. Choose a LAN team to display further details:
–
LAN Team Properties
: Properties of the selected LAN team
–
LAN Team Statistics
: Available statistics about the selected LAN team
I
For more detailed information, refer to the "ServerView Operations
Manager - Server Management" user guide.
5.2.19.1 After replacing / upgrading LAN controllers
Ê
You need to restore the configuration for the LAN Teaming, using the LAN
driver utility or OS teaming software.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I
For details, refer to the relevant LAN driver manual.
5.2.19.2 After replacing the system board
Ê
Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
Ê
If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the system board.
I
For details, refer to the relevant LAN driver manual.
To Next Page
Loading...
