490
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
System board and components
14.7.1.4 Concluding steps
Ê
Reinstall all remaining system board components as shown in the related
sections:
I
Install all components into their original slots.
– Heat sinks: "Installing heat sinks" on page 385
– Memory modules: "Installing a memory module" on page 360
– DynamicLoM module: "Installing the DynamicLoM module" on page 336
– Expansion cards:
"Installing expansion cards in standard slots" on page 295
"Installing a riser module" on page 95
– UFM (if applicable): "Installing the UFM" on page 454
– TPM (if applicable): "Installing the TPM" on page 463
– SATA DOM (if applicable): "Installing the SATA DOM" on page 473
– iRMC microSD card (if applicable): "Installing the iRMC microSD card"
on page 477
Ê
"Installing the system fan holder" on page 94
Ê
"Installing the system air duct" on page 92
Ê
"Installing a PSU" on page 147
Ê
"Reassembling" on page 74
Ê
If applicable, activate TPM functionality in the system BIOS under
Security
>
TPM (Security Chip) Setting
>
Security Chip
. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê
Reconnect all external cables.
Ê
"Connecting the power cord" on page 87
Ê
"Switching on the server" on page 90
Ê
"Updating or recovering the system board BIOS and iRMC" on page 119
Ê
"Verifying system information backup / restore" on page 121
Ê
"Verifying the system time settings" on page 132
To Next Page
Loading...
