Fujitsu PRIMERGY TX2560 M2 Upgrade And Maintenance Manual

TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual 449
Front panel and external connectors
13.2.2.4 Concluding steps
Ê
"Installing the front panel module" on page 440
Ê "Installing the system fan holder" on page 94
Ê "Installing the system air duct" on page 92
Ê "Reassembling" on page 74
Ê "Connecting the power cord" on page 87
Ê "Switching on the server" on page 90
Ê "Resuming BitLocker functionality" on page 136
13.2.3 Replacing the front VGA connector
13.2.3.1 Preliminary steps
Ê
"Suspending BitLocker functionality" on page 111
Ê "Locating the defective server" on page 55
Ê "Shutting down the server" on page 58
Ê "Disconnecting the power cord" on page 59
Ê "Getting access to the component" on page 61
Ê "Removing the system air duct" on page 91
Ê "Removing the system fan holder" on page 93
Ê "Removing the front panel module" on page 437
13.2.3.2 Removing the defective front VGA connector
Ê
Remove the front VGA connector as described in section "Removing the
front VGA connector" on page 446.
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools:
– Phillips PH0 / (+) No. 0 screw driver
– Side cutter (for cable tie)

Fujitsu PRIMERGY TX2560 M2 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX2560 M2
Category	Server
Language	English