TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
177
Hard disk drive (HDD) / solid state drive (SSD)
7.2.11.3 Installing a 2.5-inch HDD/SSD dummy module
V CAUTION!
If the removed HDD/SSD module is not replaced immediately, always
replace a dummy module into the unused HDD/SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 90: Installing a 2.5-inch HDD/SSD dummy module
Ê
Push the dummy module into the empty bay until it engages.
7.2.11.4 Concluding steps
Ê
When working on a tower server, close the HDD bay cover as described in
section "Installing accessible drive and HDD bay covers" on page 83.
To Next Page
Loading...
