222
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Hard disk drive (HDD) / solid state drive (SSD)
7.3.10.4 Concluding steps
Ê
When working on a tower server, close the HDD bay cover as described in
section "Installing accessible drive and HDD bay covers" on page 83.
7.3.11 Replacing a 3.5-inch HDD module
V CAUTION!
●
Only remove an HDD module during operation if the drive is not
currently being accessed. Observe the indicators on the HDD
module, see section "Indicators on the hot-plug HDD/SSD module"
on page 558.
●
An HDD module can be replaced while the system is in operation.
RAID configuration with a RAID controller:
Only RAID level 1, 1E, 10, 5, 50, 6 or 60 is allowed.
RAID configuration without a RAID controller:
Please follow the instruction provided separately.
●
All HDD modules (drives) must be uniquely identified so that they can
be reinstalled in their original bays later. If this is not done, existing
data can be lost.
7.3.11.1 Preliminary steps
Ê
"Locating the defective server" on page 55
Ê
When working on a tower server, open the HDD bay cover as described in
section "Removing accessible drive and HDD bay covers" on page 71.
Ê
"Locating the defective component" on page 57
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools:
tool-less
To Next Page
Loading...
Need help?
General