Fujitsu PRIMERGY TX2560 M2

TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual 383
Processor (CPU)
11.4.2.2 Installing the CPU
Ê
Install the CPU as described in section "Installing a CPU" on page 370.
11.4.3 Concluding steps
Ê "Installing heat sinks" on page 385
Ê "Installing the system air duct" on page 92
Ê "Reassembling" on page 74
Ê "Connecting the power cord" on page 87
Ê "Switching on the server" on page 90
I When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the error
message
CPU has been changed . This only indicates that the CPU
configuration has been altered. There is no technical problem.
In order to turn off the Global Error indicator, please proceed as follows:
Ê Restart the system and wait for screen output to appear.
Ê Press the [F2] function key to enter the BIOS.
If assigned, enter the BIOS password and press
[Enter] .
Ê In the Save & Exit menu, select Save Changes and Exit or Save Changes
and Reset
.
Ê Ensure that the Global Error indicator has stopped flashing. This is
only information regarding to the change of CPU configuration. There
is no technical problem.
Ê "Updating or recovering the system board BIOS and iRMC" on page 119
Ê "Resetting the error status after replacing memory modules or processors"
on page 126
Ê "Enabling SVOM boot watchdog functionality" on page 130
Ê "Enabling replaced components in the system BIOS" on page 131
Ê "Resuming BitLocker functionality" on page 136