TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
557
HDD prefailure detection
Depending on your hardware configuration HDD prefailure will be supported.
The requirements are:
– iRMC Firmware 7.14 or later
– supported OOB system
– dedicated RAID controller
17.2.2.2 Optical drive activity indicator
Figure 425: Indicator on the optical drive
I
Depending on your system configuration the activity indicator may not be
installed.
Not supported RAID controllers
D2616/MegaRAID SAS 9280-8e MegaRAID SAS9285CV-8e
D3116/D3116C D2607
Table 7: Not supported RAID controllers
Pos. Indicator Status Description
1
Activity
indicator
off optical drive inactive
green on storage medium is being accessed
To Next Page
Loading...
Need help?
General