556
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
iRMC-related status signals
I
For further information please refer to section "Updating or recovering
the iRMC" on page 119.
6
AC connected
indicator
green on
– The server is switched off and
connected to the mains
(standby mode).
– The server has been switched on
but Power Cycle Delay settings
delay it from turning on for a
specified time.
I
After connecting the server to
the mains, it will take about 60
seconds until the server will
enter standby mode and can
be switched on.
off
– The server is switched off and not
connected to the mains.
– The server is switched on and
operating normally.
ID indicator
Global error
indicator
Description
blue flashing off
A remote connection has been
established. Local VGA output has been
disabled during the remote session.
blue flashing orange flashing
An emergency flash of the iRMC firmware
is in progress.
Pos. Label Indicator Status Description
To Next Page
Loading...
