344
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
Expansion cards and backup units
9.5.4.4 Concluding steps
Ê
If applicable, install the riser module 1 as described in section "Installing a
riser module" on page 95.
Ê
"Reassembling" on page 74
Ê
"Connecting the power cord" on page 87
Ê
"Switching on the server" on page 90
Ê
"Looking up changed MAC / WWN addresses" on page 137
Ê
"Updating the NIC configuration file in a Linux and VMware environment" on
page 134
Ê
"Configuring LAN teaming" on page 140
Ê
"Enabling SVOM boot watchdog functionality" on page 130
9.5.4.5 Software configuration
Replacing with same DynamicLoM module type
If the DynamicLoM module type remains the same, no additional configuration
is necessary, because the network settings are stored on the system board.
Inform the customer about the changed WWN and MAC addresses.
Replacing with different DynamicLoM module type or replacing the
system board
If the DynamicLoM module type has been changed (e.g. 2port module was
changed to 4port module), or system board has been replaced, proceed the
same software configuration as described for first installation see section
"Software configuration" on page 340.
To Next Page
Loading...
