Philips Azurion - 7.9 Resolving a Patient Mix

For more in
formaon, see the following secons:
• Adding Annotaons (page 133)
• Creang Measurements (page 141)
7.9 Resolving a Paent Mix
If you believe images have been stored for the wrong paent, you can move them to the correct
paent using the Resolve Paent Mix wizard.
NOTE If the paent to whom you want to move the series (the desnaon paent) is not in the
paent list, you must add them before using the wizard. For more informaon, see
Scheduling a Study Manually (page 51).
1 To start the wizard, do the following:
a Click the paent selector in the upper-le corner of the acquision window.
b Select the paent whose folder contains the series you want to move.
c Right-click on the paent and click Resolve Paent Mix in the shortcut menu.
2 Verify that the source paent is correct, and click Next.
3 Select the series to move to the desnaon paent.
You can select more than one series at a me if you believe more than one series needs to be
moved. To select more than one series, select the check box in the top le corner of each series to
be moved.
4 Click Next.
5 Select the desnaon study by doing the following:
a Select the desnaon paent in the list.
A list of available desnaon studies for the selected paent is displayed.
b Select the desnaon study in the list.
6 Click Next.
7 Verify that the series to be moved and the desnaon paent are correct.
8 If they are correct, click Finish.
NOTE Aer you move the series, dose informaon is applied as follows:
• The dose informaon for the whole source study is added to the desnaon
paent. As a result, the displayed dose informaon for the desnaon paent
may be higher than the actual dose that the paent has received.
• The dose informaon is not removed from the source paent.
9 Click Close to close the wizard.
Reviewing Resolving a P
aent Mix
Azurion Release 1.2 Ins
trucons for Use 128 Philips Healthcare 4522 203 52421