EasyManua.ls Logo

Philips Azurion - 13.10 Network Configuration; 13.11 Enabling or Disabling Remote Support

Philips Azurion
402 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 On the S
ystem menu, click Customizaon to display the System Customizaon window.
2 In the General sengs group, click Automac Data Transfer.
The X-ray Image Data tab is displayed by default.
3 Select the desired X-ray protocol.
4 Select the export protocol to use for each image type.
5 Set the non X-ray image preferences using the following procedure:
a Select the Non X-ray Image Data tab.
b Select the export protocol to use for each data type.
6 To undo any changes you have made, click Undo Changes.
7 To save your changes, click Save.
8 To close the System Customizaon window, click Close.
13.10 Network Conguraon
You can congure standard network sengs on the system.
1 On the System menu, click Customizaon to display the System Customizaon window.
2 In the General sengs group, click Network Conguraon.
In the Network Conguraon panel, the current network status of the system is displayed in the
Network Adapter secon. You can Disable or Enable the network adapter as desired.
3 To set the IP address sengs of the system, click the IPv4 Sengs tab or the IPv6 Sengs tab,
depending on the networking protocol in use, and congure the IP address sengs according to
the requirements of your network.
If you are unsure of how to congure these sengs, contact your network administrator.
4 Congure the DNS Sengs according to the requirements of your network.
If you are unsure of how to congure these sengs, contact your network administrator.
The network conguraon of the system is displayed in the Network Details panel. If you have
made changes to the network conguraon, click Refresh to display the latest sengs.
5 To undo any changes you have made, click Undo Changes.
6 To save your changes, click Save.
7 To close the System Customizaon window, click Close.
13.11 Enabling or Disabling Remote Support
You can enable remote support to allow technical support to monitor the system, or you can disable
this service to prevent remote monitoring.
System Adminis
traon Network Conguraon
Azurion Release 1.2 Ins
trucons for Use 242 Philips Healthcare 4522 203 52421

Table of Contents

Related product manuals