Philips Azurion - 13.2 Configuring Audit Trail Settings; 13.3 Managing Users and System Logon

12 T
o save your changes, click Save.
NOTE The changes take eect aer the next system shutdown and startup.
13 To close the System Customizaon window, click Close.
13.2 Conguring Audit Trail Sengs
You can congure the sengs used in the system to produce audit logs.
1 On the System menu, click Customizaon to display the System Customizaon window.
2 In the General sengs group, click Audit Trail.
3 To enable the Local Audit Trail, select Enabled.
4 To enable the Remote Audit Trail, select Enabled and congure the following repository sengs.
a Enter the Host Name or IP Address of the central audit repository.
b Click the Network Protocol box and select a protocol for communicaon with the central audit
repository.
c Enter the Port Number for communicaon with the central audit repository.
d To enable secure communicaon, select Use Authencaon.
e To enable the use of encrypon, select Use Encrypon.
This opon is only available if Use Authencaon is selected.
f If Use Authencaon is selected, click the Cercate box and select a local cercate to use for
authencaon.
5 Click Test Connecon.
The result of the test is indicated by an icon.
Test successful
Test failed
If the test fails, more in
formaon is provided.
6 To undo any changes you have made, click Undo Changes.
7 To save your changes, click Save.
NOTE The changes take eect aer the next system shutdown and startup.
8 To close the System Customizaon window, click Close.
13.3 Managing Users and System Logon
You can manage user accounts and allow emergency access, or congure the system to log on
automacally when started.
System Adminis
traon Conguring Audit Trail Sengs
Azurion Release 1.2 Ins
trucons for Use 230 Philips Healthcare 4522 203 52421