Philips Azurion - 8.12 Creating a Snapshot; 8.13 Flagging Images; 8.14 Creating Measurements

8.12 Cr
eang a Snapshot
You can create a snapshot of an image, including any annotaons on the image. Snapshots are stored in
the relevant paent study as photo images.
1 Navigate to the desired image.
2 Do one of the following:
• In the toolbar, click Copy as photo image.
• Right-click on the image and select Copy as photo image.
The snapshot is stored as a photo image within the paent study.
8.13 Flagging Images
You can ag one or more images to create a selecon for exporng or prinng.
1 To ag a parcular image, use the navigaon toolbar to display the image, and then click Flag in the
toolbar.
You can display and ag other images in the series using this method.
2 To ag all images in the current series, click the arrow next to the Flag tool in the toolbar and select
Flag Series.
Images that have been agged display a ag symbol in the upper-right corner:
8.14 Cr
eang Measurements
You can create measurements on images using the Calibraon and Measurements task panel in the
Processing task.
The following types of measurements are available:
• Distance
• Polyline
• Rao
• Angle
• Open Angle
Measurements are saved with the images, and they are available if you open the images in another
applicaon on your system.
Calibraon
Calibraon is required to obtain absolute values with distance measurements. You can accept the
automac calibraon factor if it is available in the series.
To accept the automac calibraon factor, click Accept in the Calibraon and Measurements task
panel.
When you accept the calibraon factor, the informaon is added to the image informaon overlay on
the image.
Processing Creang a Snap
shot
Azurion Release 1.2 Ins
trucons for Use 141 Philips Healthcare 4522 203 52421