Philips Azurion - 2.1.3 Emergency Stop; 2.2 Electrical Safety

1 Mo
ve the detector away from the paent.
2 Ensure that there is all-round access to the paent.
If applicable, pivot the table to improve access. For more informaon, see Pivong the
Table (page 63).
3 Move the paent above the table base to reduce the eect of exing of the tabletop.
4 Adjust the tabletop height to an appropriate height.
5 Perform CPR.
2.1.3 Emergency Stop
To stop all system movements during an emergency in the examinaon room, press the emergency
STOP buon.
The emergency STOP buon is located on the control module.
Figure 1 Emer
gency Stop buon
1 Press STOP on the control module.
All motorized movements are stopped. You can manually rotate the C-arm and push the monitor
ceiling suspension.
Floang the tabletop aer an emergency stop acon depends on the following condions:
• If the lt opon is not installed, you can oat the tabletop laterally and longitudinally.
• If the VA brake opon is installed, it is not possible to oat the tabletop.
• If the lt opon is installed, and the VA brake opon is not installed, you can oat the table
laterally but not longitudinally.
2 To reset the system and restart it, press and hold the Power On buon for approximately two
seconds.
For more informaon, see Restarng the System (page 45).
2.2 Electrical Safety
Follow the electrical safety guidelines in this secon. Failure to do so could cause serious or fatal injury
to the paent, and could damage the equipment.
The room where the system is used must comply with all applicable laws and regulaons, or
regulaons concerning electrical safety for this type of equipment. The combinaon of the system and
Safety Electrical Safety
Azurion Release 1.2 Ins
trucons for Use 19 Philips Healthcare 4522 203 52421