Philips Azurion - 8.3 Adjusting Contrast and Brightness

NOTE You can also pan by dragging directly on the touch screen module. For more inf
ormaon,
see Touch Screen Gestures (page 358).
a To select whether your changes apply to the current image only or to all images, tap Scope and
select an opon.
–
Apply changes to the current image only.
–
Apply changes to all images in the series.
4 T
o display the complete image in the center of the view again, click Reset in the control panel.
8.3 Adjusng Contrast and Brightness
To assist you when reviewing images, you can adjust the contrast and brightness levels independently.
1 To adjust contrast and brightness using the mouse directly on the image, click Contrast and
brightness on the toolbar in the acquision window or review window, and do the following:
• Drag upward to decrease the brightness level.
• Drag downward to increase the brightness level.
• Drag to the right to decrease the contrast level.
• Drag to the le to increase the contrast level.
2 To adjust contrast and brightness in the task panel, do the following:
a Select the Processing task and click Contrast, Brightness, Edge.
b Adjust the Contrast and brightness sliders.
c T
o apply the changes to the current image only, select Adjust current image only.
3 To adjust contrast and brightness on the touch screen module, do the following:
a Select the Processing task and tap CBE.
b Use the Contrast and brightness controls.
Processing Adjusng Con
trast and Brightness
Azurion Release 1.2 Ins
trucons for Use 131 Philips Healthcare 4522 203 52421