Philips Azurion - 11.1.14 Accessory Rail Clamps; 11.1.15 Handgrip and Clamp Set

5 T
o decrease the compression, push the release lever down and turn the ratchet winder counter-
clockwise.
6 To release the compression band when the procedure is nished, do the following:
a Push the release lever down.
b Release the band from the compression band roller.
c Rewind the band by turning the ratchet winder counter-clockwise.
d Remove the unit from the edge of the table.
11.1.14 Accessory Rail Clamps
Accessory rail clamps allow you to aach compable accessories to the table accessory rail.
1 Slide the clamp on to the accessory rail.
Figure 96 P
osioning the clamp on the accessory rail
2 Fit an accessory in the clamp.
Figure 97 Fing an accessor
y in the clamp
3 Turn the knob on the clamp so that the clamp and accessory are rmly aached to the accessory
rail.
When a clamp does not have an accessory ed, it should be removed from the rails.
11.1.15 Handgrip and Clamp Set
The handgrip and clamp set provides safety and comfort for the paent during lt or cradle
movements.
1 Aach a tabletop accessory clamp on each side of the table at the appropriate posion.
Using Other Equipment Accessories
Azurion Release 1.2 Ins
trucons for Use 195 Philips Healthcare 4522 203 52421