Philips Azurion - 11.1.12 Neuro Wedge; 11.1.13 Ratchet Compressor

11.1.12 Neuro Wedge
Y
ou can use the neuro wedge to posion the paent's head in the isocenter posion during neuro-
radiology procedures. The neuro wedge should be used with the head support. For more informaon
about the head support, see Head Support (page 193).
1 Slide the tapered end of the neuro wedge under the maress at the head end of the table so that
only the rectangular poron of the wedge is visible.
2 Posion the head support on top the rectangular part of the neuro wedge.
3 Posion the paent so that the paent's head lies comfortably in the head support.
Figure 94 P
osioning the neuro wedge
11.1.13 Ratchet Compressor
The ratchet compressor applies moderate compression to the paent and minimizes paent
movement. This improves visualizaon of internal organs.
1 Posion the unit on the edge of the table and ghten the aachments underneath the unit.
2 Push the release lever down to release the compression band.
3 Pass the compression band over the paent and back under the table, and then put the end of the
band over the compression band roller.
Figure 95 Fing the c
ompression band
4 Turn the ratchet winder clockwise to increase the compression.
Take care to control the amount of compression.
Using Other Equipment Accessories
Azurion Release 1.2 Ins
trucons for Use 194 Philips Healthcare 4522 203 52421